Product Overview

Perma-Gloss Fluorourethane is a two component high gloss fluorourethane coating that substantially increases long-term color and gloss retention when compared to conventional urethane finish coatings. Available in a virtually unlimited color range, this high performance coating delivers exceptional chemical and stain resistance in aggressive environments. Perma-Gloss Fluorourethane meets the finish coat requirements of ANSI/AWWA D102-11 System OCS-4 and contains a factory added mildewcide.

Application Specifications

Application Methods

Brush: Use natural bristle brush only

Roller: Use 3/8" or 1/2" synthetic nap roller. Thin if necessary up to 10% with Induron K-1017 Reducer. Roll out evenly over suitable area while keeping roller wet. Roller strokes should be parallel and in the same direction. Avoid dry rolling.

Airless Spray: Not usually recommended but can be applied using .015-.019 tip, 60 mesh filter, 30:1 pump ratio at 60-100 operating psi

Thinning

Use K-1017 at up to 15% by volume for roller application. Thinning not normally required for spray application though K-1017 may be used at up to 10% by volume.

Application Temperature: Use this product only if the substrate temperature and ambient air temperature is above 40°F and is expected not to decrease for at least two hours after application. The substrate temperature must be 5°F above the dew point for at least two hours after application.

Surface Preparation & Use

Recommended Use

Use as the exterior finish coat for tanks and other exposed steel and non-ferrous substrates. This fluorourethane finish coat provides the benefit of extremely long-term maintenance cycles.

Compatible Substrates

Apply Perma-Gloss Fluorourethane over the following properly prepared surfaces:

• • Indurethane 6700 Flat
• • Indurethane 6600 Plus
• • Permastic Polyurethane Satin or Gloss
• • Induron Epoxies

Surface Requirements: Surface must be clean, dry and free of chalk.