Product Overview

Novasafe is a heavy-grade industrial tank lining that may be used as a liner for steel or concrete wastewater tanks. This Novolac Epoxy Liner may also be specified for immersion service in other treatment plant services with heavy chemical stress, providing exceptional protection in demanding environments.

Chemical Services & Applications

Novasafe is designed for demanding chemical environments including:

• • Mineral acids, bases, and high hydrogen sulfide environments
• • Wastewater influent and secondary containment
• • Concentrated hypochlorites and acids
• • Primary and Secondary Clarifiers
• • Aeration Basins
• • Chlorine Contact Chambers
• • Water and Wastewater Influent Channels

Contact Induron Technical Service for specific concentration based chemical immersion service recommendations at 1-800-324-9584

Application Specifications

Application Methods

This is a high build and high solids coating with multiple application options:

Plural Airless Spray: Remove all filters from spray system, use Graco XP-70 or equivalent heated plural spray unit with heated hose bundle and in-line static mixer. 0.027-0.031 spray tip. Heat A component to between 70 and 85°F, do not heat part B above 75°F. Spray at minimum line pressure to achieve fan.

Single Leg Airless Spray: Remove all filters from spray system, use pump capable of 2,000 psi line pressure; 0.027-0.031 spray tip. Do not heat material above 85°F

Brush and Roll: Recommended for small areas only. Use K-1070 or K-1034 at up to 10% by volume for stripe coating

Cure Schedule

Pot Life

At 50°F: 90 minutes | At 75°F: 50 minutes

Surface Preparation

All substrates must be clean and dry, free of dirt, oils, greases and contaminants.

Carbon Steel

Abrasive blast to SSPC SP-10 with a 1-3 mil profile

Concrete

Abrasive blast as per SSPC SP-13 to an ICRI CSP 3 or greater. Can be applied over Mortarchem and EFS 707

Repairs, Small Areas

SSPC SP-11 power tool to bare metal to produce an angular profile